Impact of Frequency Variations in Ultrasonic Transducers on Material Properties

Sri Maiyena; Shahrul Kadri Ayop; Anis Nazihah Mat Daud

doi:10.20527/flux.v21i2.17166

Impact of Frequency Variations in Ultrasonic Transducers on Material Properties

Sri Maiyena, Shahrul Kadri Ayop, Anis Nazihah Mat Daud

Abstract

Research has been carried out to determine material properties using ultrasonic waves. The aim of the research is to see the effect of variations in ultrasonic transducer frequency on material properties, material mechanical properties and material acoustic properties. The ultrasonic technique used is based on the pulse echo technique. The samples used were steel with a thickness of 2.5 cm, aluminum with a thickness of 2 cm and 1.8 cm and PMMA with a thickness of 1.5 cm, 1 cm and 0.2 cm. There are three variations of transducer frequency used, namely 2.25 MHz, 5 MHz and 10 MHz. The mechanical property of the material that will be determined is the elastic modulus. The acoustic properties of the material to be determined are longitudinal velocity, attenuation coefficient and acoustic impedance. The results showed that variations in transducer frequency did not affect the values of elastic modulus, longitudinal velocity and acoustic impedance. However, the use of transducer frequency variations affects the attenuation coefficient value.

Keywords

: frekuensi transduser; gelombang ultrasonik; sifat akustik bahan; variasi

Full Text:

PDF (Bahasa Indonesia)

References

Abd-Shukor, R., Tan, L.K., Nik-Jaafar, N.A., and Mohd Nasir, M.N., 2022. Atenuasi Ultrasonik dan Modulus Ricih pada Suhu Genting Superkonduktor Terdop Sederhana (Tl0.8Bi0.2)Sr2(Ca0.9Cr0.1)Cu2O7. Sains Malaysiana, 51 (9), 3095–3101.

Agus Syafrudin, Suryono, J.E.S., 2008. Rancang Bangun Generator Pulsa Gelombang Ultrasonik Dan Implementasinya Untuk Pengukuran Jarak Antara Dua Obyek. Berkala Fisika, 11 (2), 29–37.

Al-aboodi, A.S. and Al-nasser, A.A., 2014. Bone Porosity Modeling and FE Simulation. Advances in Mechanical, Aeronautical and Production Techniques, (December), 0–5.

Amares, S., Sujatmika, E., Hong, T. W., Duraairaj, R., & Hamid, H.S.H.B., 2017. A Review: Characteristics of noise absorption material. Journal of Physics: Conference Series, 908 (1–9).

Azhari, H., 1955. Basics of Biomedical Ultrasound for Engineers. John Wiley & Sons. New Jersey.

Bias, S., Rambat, C., S, R.D., Hendroprasetyo, W., and Putera, A., 2012. Pengaruh Ketebalan Cladding Terhadap Deviasi Gelombang Suara pada Pengelasan Baja Karbon dengan Stainless Steel, 1 (1), 1–4.

Cheeke, J.D.., 2000. Fundamentals and Applications of Ultrasonic Waves. CRC Press LLC. Florida.

Choi, W.Y., Kang, K.C., and Park, K.K., 2020. Ultrasonic fingerprint sensor in under- glass prototype using impedance mis- matching, 34 (2).

Duck, F.A., 1990. Physical properties of tissue: a comprehensive reference book. London: Academic Press Limited.

Fathoni, M.H., Pirngadi, H., and Rivai, M., 2013. Perancangan, pembuatan dan karakterisasi tranduser ultrasonik 3,5 MHz untuk pengujian bahan padat. J Teknik Pomits, 2 (2), 306–311.

Greenwood, C., Clement, J.G., Dicken, A.J., Evans, J.P.O., Lyburn, I.D., Martin, R.M., Rogers, K.D., Stone, N., Adams, G., and Zioupos, P., 2015. Bone Reports The micro-architecture of human cancellous bone from fracture neck of femur patients in relation to the structural integrity and fracture toughness of the tissue. BONR, 3, 67–75.

Hadi; T. Amoranto; V. Frinsyah; K. Deddy, 2010. Pengukuran kecepatan dan amplitudo gelombang ultrasonik untuk klasifikasi kualitas batubara. Jurnal Penelitian Sains, 13 (1 (B)), 1–5.

Hagan, C.P., Orr, J.F., Mitchell, C.A., and Dunne, N.J., 2015. Critical evaluation of pulse-echo ultrasonic test method for the determination of setting and mechanical properties of acrylic bone cement : Influence of mixing technique. Ultrasonics, 56, 279–286.

Haryanto, B., Budiastra, I., and Trisnobudi, A., 2000. Hubungan Antara Sifat Fisik dan Gelombang Ultrasonik Durian Utuh dengan Sifat Fisiko Kimia Daging Durian. Buletin Teknologi dan Industri Pangan, XI (2), 28–32.

He, P., 1999. Experimental verification of models for determining dispersion from attenuation. IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 46 (3), 706–714.

Hendee, W.R., Ritenour, E.R., and Hoffmann, K.R., 2003. Medical Imaging Physics, Fourth Edition. Medical Physics, 30 (4), 730–730.

Heri Sugito, S.D.L., 2009. Aplikasi Transduser Ultrasonik Jenis Immersion Transducer Untuk Karakteristik Media Cair Dan Pengukuran Tingkat Kekasaran Permukaan Beton. Berkala Fisika , 12 (4), 137–144.

Ishimoto, T., Suetoshi, R., Cretin, D., Hagihara, K., and Hashimoto, J., 2019. Quantitative ultrasound ( QUS ) axial transmission method re fl ects anisotropy in micro-arrangement of apatite crystallites in human long bones : A study with 3-MHz-frequency ultrasound. Bone, 127 (April), 82–90.

Jakovljevic, M., Hsieh, S., Ali, R., Chau, G., Kung, L., Hyun, D., Dahl, J.J., Jakovljevic, M., Hsieh, S., Ali, R., Chau, G., Kung, L., Hyun, D., and Dahl, J.J., 2018. approach Local speed of sound estimation in tissue using pulse-echo ultrasound : Model-based approach. Acoustical Society of America, 144 (Jully).

Juansah, J., Budiastra, I.W., and Suroso, 2006. Pengembangan Sistem Pengukuran Gelombang Ultrasonik untuk Penentuan Kualitas Buah Manggis (Graciniamangostana L). Jurnal Keteknikan Pertanian.

Kim, Y., Lee, B., Kim, Y., and Lee, B., 2011. Novel approach to the fabrication of an artificial small bone using a combination of sponge replica and electrospinning methods. Science and Technology of Advanced Materials, 6996 (May).

Laugier, P. and Ha, G., 2011. Introduction to the Physics of Ultrasound, 29–45.

Lee, K.I., 2011. Dependencies of acoustic properties on the frequency and the porosity for Biot’s slow wave in water-saturated copper foams. Journal of the Korean Physical Society, 59 (4), 2721–2726.

Liu, Z., Zhan, J., Fard, M., and Davy, J.L., 2017. Acoustic properties of multilayer sound absorbers with a 3D printed micro-perforated panel. Applied Acoustics, 121, 25–32.

Nurmalia, N., 2021. Electromagnetic Acoustic Transducer (EMAT) sebagai Transduser Ultrasonik untuk Nondestructive Testing (NDT): Ulasan Artikel. Jurnal Otomasi Kontrol dan Instrumentasi, 13 (1), 1–14.

Qodir, F. and Putra, J.A., 2016. Tranduser Ultrasonik Sebagai Pendeteksi Gerak Pada Sistem Keamanan Rumah. Semesta Teknika, 8 (1), 61–71.

Rahma, S.N., Suryani, S., and Nurdin, W.B., 2018. Pengukuran Intensitas Gelombang Ultrasonik Yang Terserap Pada Pemeriksaan Kehamilan. Seminar Nasional Fisika Makassar, 142–145.

Rose, J.L., 2004. Ultrasonic waves in solid media. United Kingdom: Cambridge University press.

Sanabria, S.J., Martini, K., Freystätter, G., Ruby, L., Goksel, O., Frauenfelder, T., and Rominger, M.B., 2019. Speed of sound ultrasound : a pilot study on a novel technique to identify sarcopenia in seniors. European Radiology, 29, 3–12.

Sanjaya, E.R., Muninggar, J., Setiawan, A., and ..., 2022. Uji Coba Metode Pencitraan Multimodalitas Ultrasonografi Dan Fotoakustik. Jurnal Fisika: Fisika Sains dan Aplikasinya, 7 (1), 8–14.

Sasmita, F., Claudia, C., Wibisono, G., Tarigan, T.Z.S., Judawisastra, H., and Priambodo, T.A., 2019. Penentuan Modulus Elastisitas Logam Dengan Metode Ultrasonik Pulsa Gema. Jurnal Teknologi Bahan dan Barang Teknik, 8 (1), 27.

Umiatin, Oktaviana, T., Wijaya, E., Riandini, and Yusuf, F., 2021. The bone microstructure identification model based on backscatter mode of ultrasound. SPEKTRA: jurnal Fisika dan Aplikasinya, 6 (July).

Widharma, I.G.S., 2020. Sensor Ultrasonik dalam Water Level Controller. Politeknik Negeri Bali 2020, 1 (1), 1–11.

Wrobel, G. and Pawlak, S., 2007. A comparison study of the pulse-echo and through-transmission ultrasonics in glass / epoxy composites. Journal of Achievements in Materials and Manufacturing Engineering, 22 (2).

Xu, K., Ta, D., He, R., Qin, Y.X., and Wang, W., 2014. Axial transmission method for long bone fracture evaluation by ultrasonic guided waves: simulation, phantom and in vitro experiments. Ultrasound in Medicine & Biology, 40 (4), 817–827.

Yang, X., Fei, C., Li, D., Sun, X., Hou, S., Chen, J., and Yang, Y., 2020. Multi-layer polymer-metal structures for acoustic impedance matching in high-frequency broadband ultrasonic transducers design, 160.

Yunitasari, D., 2009. Karakterisasi Atenuasi Ultrasonik Terhadap Variasi Tebal Bahan (Cairan) Menggunakan Transduser Ultrasonik Jenis Immersion Trasnducer, 1–6.

Zou, Z., Hao, Y., Tian, F., Zheng, Y., He, W., Yang, L., and Li, L., 2020. An ultrasonic longitudinal through-transmission method to measure the compressive internal stress in epoxy composite specimens of gas-insulated metal-enclosed switchgear. Energies, 13 (5), 1–21.

DOI: http://dx.doi.org/10.20527/flux.v21i2.17166