PENGERASAN (HARDENING) RODA GIGI SPROCKET SEPEDA MOTOR DENGAN VARIASI WAKTU PENAHANAN DAN MEDIA PENDINGIN

Kris Witono; Subagiyo Subagiyo

doi:10.20527/infotek.v18i1.3883

PENGERASAN (HARDENING) RODA GIGI SPROCKET SEPEDA MOTOR DENGAN VARIASI WAKTU PENAHANAN DAN MEDIA PENDINGIN

Kris Witono, Subagiyo Subagiyo

Abstract

Motorcycle problems with large (cylinder / cc) engines are generally located on the sprocket gears that are rapidly wearing wear. The objective of this study was to increase the hardness of sprocket gears, while improving their wear resistance through hardening heat treatment process with variation of holding time and cooling medium. The research method included heating the specimen up to its critical temperature (850 ° C), retained with variations of holding time of 30, 60, and 90 minutes, then cooled rapidly (quenching) on water cooling, brine, and oil variations. The results showed an increase in the hardness of sprocket gears, with maximum hardness increases occurring at 30 minutes and 30 minutes of brine cooling.

Keywords

sprocket gears, hardening, hardness, hold time, cooling media

Full Text:

PDF

References

Anonim. 1984. Teknologi Bahan. PEDC. Bandung.

Avner, Sidney H. 1994. Introduction to Physical Metallurgy. 4th Edition. Mc Graw Hills. New York.

Ismanhadi S., Mohammad dan Setyorini, Yuli. 2013. Pengaruh Media Pendingin pada Proses Hardening terhadap Strukturmikro Baja Mangan Hadfield AISI 3401 PT Semen Gresik. Jurnal Teknik POMITS Vol. 2, No. 2, (2013) ISSN: 2337-3539 (2301-9271 Print).

Pollack, Herman W. 1981. Material Science and Metallurgy. 3rd Edition. Reston Publishing. Virginia.

Pramono, Agus. 2011. Karakterisrik Mekanik Proses Hardening Baja Aisi 1045 Media Quenching Untuk Aplikasi Sprochet Rantai. Jurnal Ilmiah Teknik Mesin Cakram Vol. 5 No.1. April 2011. pp32-38.

Suherman, Wahid. 1990. Perlakuan Panas. Jurusan Teknik Mesin FTI – ITS. Surabaya.

Tata Steel. 2015. AISI 4140. https://www.tatasteeleurope.com/file_source/StaticFiles/Speciality/publications/oil_gas/UK%20Datasheet/april14/AISI_4140_UK.pdf. Diakses 15 April 2017.

Thelning, Karl-Erik. 1984. Steel and Its Heat Treatment. 2nd Edition. Butterworth & Co. London.

DOI: http://dx.doi.org/10.20527/infotek.v18i1.3883

DOI (PDF): http://dx.doi.org/10.20527/infotek.v18i1.3883.g3517