RESETTING VERTICALITY FLARE STACK DENGAN PENGATURAN TEGANGAN GUY WIRE

Sulardi Sulardi; Sabar P. Simatupang; Lukman Lukman

doi:10.20527/infotek.v22i1.11627

RESETTING VERTICALITY FLARE STACK DENGAN PENGATURAN TEGANGAN GUY WIRE

Sulardi Sulardi, Sabar P. Simatupang, Lukman Lukman

Abstract

The flare stack is an important installation in the oil and gas industry as a tool to burn off-specification gas so as not to harm the environment. The problem faced is that there is a slope on the riser vertical stake so that it exceeds the safe limit (out of tolerance). The purpose of this research is to determine the method of resetting the riser flare stack so that the verticality returns to the uprightness as required by API 521. The method of resetting the verticality flare stack is carried out by adjusting the tension on all guy wire support vertical riser stacks so that each receives a voltage of 1.2 - 1.4 tons and mutually eliminate the stresses that occur when the riser stak gets a load from the outside or as a result of plant operations. The results showed that the guy wire support tension resetting method was proven to be suitable and suitable for use properly and safely with a maximum erection of 145 mm (1/800L) vs. API 521 standard tension maximum of 232mm (1/500L). The results of this study also recommend that the resetting work method that has been proven to be suitable and suitable for use can be replicated to overcome problems in the Pertamina other unit.

Keywords

flare stack, uprightness, safety limit.

Full Text:

PDF

References

API Standard 521, 2014, Pressure-Relieving and Depressuring Systems, Six Edition, Nuw York, USA

Document No.1569-001,Job No. 1569, 1996, Data Sheet of Flare Stack, Balikpapan Expansion Program, PT.Pertamina UP V, Balikpapan

Peraturan Pemerintah (PP) No. 11 Tahun 1979 tentang Keselamatan Kerja pada Pemurnian dan Pengolahan Minyak dan Gas Bumi.

Sulardi, 2021, Inspeksi Teknik Instalasi Flare Stack Industri Migas dan Tindak Lanjutnya, Jurnal Petrogas, Vol. 2 No.1, Sekolah Tinggi Teknologi Migas Balikpapan

Sulardi, 2019, Peralatan Industri, Penerbit Nusa Litera Inspirasi Kab. Cirebon, Jawa Barat, Indonesia

Sulardi, 2019, Pengantar Industri Minyak dan Gas Bumi, Peberbit Nusa Litera Inspirasi, Kab. Cirebon, Jawa Barat, Indonesia

Sulardi, 2019, Mermanfaatkan Condensate Hydrocarbon Natural Gas Sebagai Fuel Gas Dengan Pengaturan Kondisi Operasi Alat Heat Excganger, Jurnal Info Teknik Vo. 20 No.2, Desember 2019

Sulardi, 2018, Analysis of Failure Base Plate Anchor Flare Stack Foundation and Repair Method, International Conference on Geotechnics (IC Geotechnics) Sustainable Development Challlengeres in Geotechnics, 24-26 July 2018, Yogyakarta, Indonesia.

Sulardi, 2017, Reposisi Pipa Transfer Line Flare Stack Dengan Alat Roll Geser dan Metode Penarikan, Jurnal Teknologi Bahan dan Barang Teknik (B4T), Vo. 7 No.2 Desember 2017, Bandung

UOP, 2014, Callidus Flaress For The Petrochemical and Petroleum Industry, UOP Honey Well, USA.

DOI: http://dx.doi.org/10.20527/infotek.v22i1.11627

DOI (PDF): http://dx.doi.org/10.20527/infotek.v22i1.11627.g7391